Squeeking and slowing down

After trying the beta Pass through software, my cameras were acting a little squirrly. Rebooting seemed to fix that but now, on a regular (simple) 2 minute cut on PG acrylic, the movement of the head seemed very loud (squeeky). As if the belts were binding or something needs lubrication… and also the movement of the head changed speed in a manner that seemed erratic. At point, it slowed down so much I thought it was going to stop.

Any ideas?

Are the carriage wheels intact?

Yes, I think so. Maybe it was my imagination…
:crazy_face:
It seems fine now

1 Like

I’m so sorry to hear that you’ve hit this snag! I’m glad to hear that the trouble has improved, and you have not run into the same trouble. I’ll close this thread for now, but please don’t hesitate to reach out to us directly at support@glowforge.com if you happen to notice the same behavior occurring.