Trying to use the passthru on my pro... but I don't know how to layer my Ai design. HELP!

[Jules]

There are a couple of tutorials for it here:

Passthrough Alignment Tutorial with Manual Indexing

I wanted to test some theories about pass-through use and to create a tutorial about how we can work around the camera alignment inaccuracies in the current state of the Glowforge software. To spoil the ending, here’s the final product: [final] I’ll be using Adobe Illustrator CC 22.0.1 (current version) primarily because I have a subscription via work. However, I am a total newbie with AI, so please feel free to point out other/better ways to do things if I end up doing them the hard way. I w…

Pro Only - Passthrough Alignment Jig Templates

So I got my Pro right before Thanksgiving. I won’t go into too much detail since there are still folks waiting, but…Wowzers!..Yes, it was totally worth the wait. I had an unrelated computer issue that kept me from playing with it for a couple of days, but i got that squared away, did a little Christmas gift prep, and finally got around to trying the passthrough slot for a couple of small test runs. I essentially used the method laid out by @johnse here, Passthrough Alignment with Manua…

Using Inkscape with the Passthrough

Notice to new owners looking for instructions on how to use the Passthrough: Glowforge has now developed their Passthrough software and it is much easier to use than the method described below. The link to the Glowforge tutorials for using their Pro Passthrough software can be found here: Using Inkscape with the Passthrough I got a private message for some assistance in creating a file for Passthrough use in Inkscape. (A caveat up front, I’m not an Inkscape expert and there might be an…

(I’d read the third one Inkscape too, it’s laid out a little more “step-by-step” and easily adaptable to Illustrator.