I am trying to cut very thin rubber, but the fan that turns on while the laser is running is blowing the material around. Is there any way to change the setting of the fan?
Alternatively, is there something I can buy to put on the rubber first to keep it from moving? Like how the proof grade material has a covering on it that peels off?
Stick it onto a stiff surface. My brother @timjedwards taught me to use MDF with a light coat of spray adhesive, for cutting paper. Seems that would work just as well here.
It’s been a little while since I’ve seen any replies on this thread so I’m going to close it. If you still need help with this please either start a new thread or email support@glowforge.com.