You successfully connected your Glowforge to HTDLG

after i connected my laptop to the GF wifi then connected it to my wifi i get this message. “You successfully connected your Glowforge to HTDLG”
the please wait has been flashing for half an hour. Am i suppose to wait that long?
if not, what do i do.

Power cycle, and do the wifi connection step again–was maybe a weird hiccup–or is there a network available called “HTDLG” you unintentionally selected?

But if continues to not connect properly there should be a more informed advice/reply soon.

Sometimes the please wait page gets hung up and your computer doesn’t go back to the home network.

Go to and you should be good to go.

1 Like

Welcome to the forum. Did you get operational?

Hi @mikeyp783! I see you already emailed us about this and we’re working on it there, so I’m going to close this topic.