A new look on dimensions

[dan_berry]

Past comments from Dan:

Does the GlowForge filter have to sit directly beneath the GlowForge?

The info above is more or less correct - the filter was designed to have the Glowforge on top, and proper operation depends on them being arranged that way.

Can you have the filter and main unit separate?

Air filter pointless? Exhaust & air filter combo?

By the back and forth on this thread it is clear we still have no where near enough info to do anything more than speculate as to the design of the filter or the GF filter interface. Also keep in mind there is likely some sort of common control. If I remember correctly the fans on the filter and cutter are controlled through the cloud,. That might mean an electrical control between the units. Until we touch a filter or see a demo everything is still guesswork.

…to which Dan replied:

Air filter pointless? Exhaust & air filter combo?

Correct. No, because… also… I’m not going to tell you it’s impossible, just that it’s nontrivial. Very nontrivial.