ekla
January 8, 2022, 8:28pm
6
Since you took the tray out you’ll need to prop up that knife up into laser range to get an accurate photo for placement. That’s within 1/2” of the head.
This tool helps to figure out the right height
Leveraging the recently-released Set Focus tool, I’ve designed a tool to help place materials when the crumb tray has been removed, no maths required.
If your material is between the lines while resting on the bottom of your GF – not the crumb tray, you should be able to use Set Focus in the UI. If the top of your material is below the bottom line, use your favorite method (sheets of PG, tiles, 3-D printed stands, matching sets of trained hedgies, etc.) to elevate it and recheck. Repeat until …
3 Likes
