Calibration Wi-Fi Dropping, Error in Focus

I have troubleshot on my own and then further with the following three similar posts however to no avail… it doesn’t seem there was any solution on the posts and I am still having the error without any successful progress. Hoping someone can let me know the steps AFTER this process and how to go about it!!

The camera calibration is very sensitive to wifi signal strength for some reason.

If it’s not working well with your home wifi, you can temporarily connect your Glowforge to a mobile hotspot (that you make with your phone) instead.

You’d do that by holding down the big button for about 10 seconds until it turns teal, then going through the wifi setup at and choosing your hotspot name instead of your home network’s name to connect to.


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.