DIY - Easy simulated wood inlay using veneer (aka "fancy plywood")

[evansd2]

@ekla

laser through standard wood glue

No problems at all.

I know @geek2nurse has made really thin plywood out of veneers, and it inspired me to do it too for this project:

Bubeenga

I am the keeper of the comb. You may look, but do not touch. [image] I’d seen the bee model kicking around on the forum for a while and always thought it looked fun, so I decided to take a crack at it. I had seen other people’s takes on it, but I decided that smaller was where I wanted to be. Notes: Two Three layers of bubinga veneer, glued up cross-grain. Total thickness 0.063" Unmasked. This is unusual for me, so thought I’d mention it. I made the slots intentionally looser than my us…

Standard wood glue never presented a problem.