Engrave quality and alignment off

[Jules]

That’s a Pro model. Check this:

Red Cable hanging up on Heat Sink Fins - fixed

Hmmmm. That can be caused by a cable with too much slack in it under the gantry getting hung up on the fins of the heat sink. To check for it, you need to turn the machine off, drop the front door, grab a flashlight and get down so that you can see underneath the gantry on the left side. There is a red cable that runs the length of the gantry, you can see it through the tube if it’s clean…locate that cable, keep your eyes on and slowly push the gantry back to the rear. If you see the cable c…

Start at the direct link and read down the thread for pictures.