Sorry for your loss.
If you’re looking for a file that has a rose on it - there are definitely those. To get a file, go to the post, right click on the line drawing, and select Save As - then drag or upload those to your Glowforge (
A few options:
Hey All, I realize this is super last minute and maybe even very basic but I wanted to add an acrylic rose inlayed into wood. My drawing skills are not much but I think I have figured out a good kerf adjustment for the medium proofgrade materials I was using. I used the black cut line for the entire rose on the medium ply, then I used the red and green cut lines for the flower parts. The parts flip back into the wood cut out upside down. was a snug fit for me but might need further adjustments …
I’m just getting started designing. We are in Port Isabel tx…without my glowforge…
Made a little tote for Mother’s Day and thought I’d share.
I used
-PF hardwood Maple for the top and sides
-PF med. draftboard for the bottom (could use hardwood too)
For the handle:
-I placed a large sheet of PF in the bed and used magnets to hold it firmly in place so I could use it as a jig.
In the file, I placed a square around the flower bitmap to make it easier to engrave both sides. I engraved and cut out the square, then flipped it over and engraved the other side. Next I pla…
If you’d like to see what other folks have done for memorials, try these:https://community.glowforge.com/search?q=memorial%20%23free-laser-designs
8 Likes
) user interface (GFUI)