Passthrough Saying Unsuccessful, despite and successful print and will not allow me to manually align

[rbtdanforth]

I laid out how I did it before passthrough, and still usually use here…

Pass Through print expired getting expensive

I use a system that I did before there was pass-through. I break the design into ~10" pieces so they break at specific locations that are 90 degrees or do not connect where (unlike regular passthrough) they don’t have to be in the same line. Then I line up the material against the right-hand rail so that holds the horizontal and the rotation fixed. Then at each cut, you have only the vertical to worry about. If you keep to the right-hand rail and only use the vertical arrow keys to move the de…