Passthrough will not engage

[rbtdanforth]

You have to follow the instructions carefully. Especially starting at the bottom of the design and moving towards the front. I laid out the system I used before they had that system and still prefer here:

Pass Through print expired getting expensive

I use a system that I did before there was pass-through. I break the design into ~10" pieces so they break at specific locations that are 90 degrees or do not connect where (unlike regular passthrough) they don’t have to be in the same line. Then I line up the material against the right-hand rail so that holds the horizontal and the rotation fixed. Then at each cut, you have only the vertical to worry about. If you keep to the right-hand rail and only use the vertical arrow keys to move the de…