Stuck on "lid open" right after I did other prints

[geek2nurse]

For the placement that’s off (after things are working again), turn the GF off and back on to reset the head calibration, then make sure you’re using the new set focus tool in the target location before you print.

For the lid open error, do this:

"Lid Open" Error

I’m so sorry to hear you’re having problems. Could you do the following for me? Power off your Glowforge Open the lid and front door of your Glowforge Remove your crumb tray Check for and remove any debris that may prevent the front door from closing properly, particularly the area underneath the front door Close the front door and lid Power your Glowforge back on If you’re still receiving the Lid Open message without the crumb tray installed, please take a look at the follo…