Having a lot of difficulty using the GF when the material is greater than 0.5 inch.
With the GF off, I remove the crumb tray, place item in center, move GF head under lid camera, close lid, turn on GF and allow to calibrate.
In the APP, I upload my image (engrave), center it on the material. When I go to set the thickness, I type in 0.75, hit submit and it automatically reverts to 0.5. It does this every time. I have even tried changing my input to 0.74 or 0.76 as suggested elsewhere here with no luck.
I have a number of jobs that need to be run on 3/4 and higher material but with this alignment issue, it is not safe to do so.
Help is as always, appreciated.