Out of Focus

[evansd2]

I prefer two-edged jigs but a one edge would probably work too.

Not a bad tutorial for a three-edge setup:

Tutorial - Batch Production With a Jig

A number of people have mentioned their intent to use the glowforge for repeated creation of a design. I am currently in the process of doing that for some wedding invites, so I figured I would show you guys how im going about it, as you might find it helpful in your own exploits. This is going to be long winded, so be prepared. Lets get started Some good friends of mine are getting married. They are both graphic designers and wanted some cool invites, and I happen to have a laser… so I said ‘…

Also not bad:

Cardboard jig test

I was reading some of the other other discussions on absolute zeros, positioning jigs, etc. and decided to give it a try. I just received an Amazon package and figured I might as well dial in settings for cutting it as well (0.1" focus, 200/60; speed may be able to be increased even more). First, I checked the bed stability, and it wasn’t terrible. Front to back and side to side, it doesn’t move detectably, so I figured it was good enough to give it a go. I cut a 9x12 rectangle with the laser,…

Again, just searching jig will yield a huge trove.