Glowforge Owners Forum

Laser light

Community Support

marmak3261 December 7, 2019, 4:31am 3

Burnt lens, shop says it is out of stock, will not allow me to order a replacement Community Support

[20190420_092946] shop says out of stock, will not let me order. That seems dumb, why force the customer to keep circling back to check back order status? Easier on your customer if you notify then just take the order and ship when available.

Pinhole sized hole in lens and burn Community Support

Hey all, So I’ve been forging for about an hour each night this past week. (My wedding is on Saturday so I’m making my groomsmen some gifts!) I last cleaned my GF last week and all has been swell. However today i noticed a burned out hole in the lens on the GF. (The lens we remove with that little remove tool) Oof…bummer. See the attached photo. Does anyone know what caused this? My GF is stuck on focusing now so i think i’m screwed (And i only have one groomsman gift to go…) [20190506_2056…

Lens Fail: Burnt O-Ring; Not Cutting Through Material Community Support

Gacked Lens Housing: [IMG_5357] I set up my Glowforge according to the directions in the owner’s manual. I successfully cut two Gift of Good Measure (Glowforge - the 3D laser printer) files. [IMG_5320] Then I tried to cut a custom file based on the Print a Gift Tag (https://glowforge.com/support/topic/first-three-prints/3rd-print-gift-tag). Unsuccessful. So I tried cleaning the lens as suggested here: HELP! Not cutting all the way through gifts! I followed the directions for cleaning an…

Yes It has happened. One can replace the lens. Now to figure out how it happened.

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled