Examples of Working Alignment

[karaelena]

@rpegg

I’ll show my alignment only because the problem units are always the most remembered.

Funny how that works.

Pre-Release | Engraving Aluminium

Couple test engraves on anodized aluminum. [image] [image] [image]

/uploads/db6859/optimized/2X/3/3e231a456775458c2d3d62160811a6c1d5469798_1_281x500.JPG

Pre-Release | I am Groot

In this week’s episode of lazyCAD, I make a base for a 3D print of baby groot with no measurements. I started out with the look I wanted to achieve with the base. [image] Then export that out and sprinkle some logo love. [image] Then slap baby groot in the glowforge and do a size check. Resized where needed. [image] Click the print button. Then press the only button on the 'forge. [image] Baby groot felt like he needed to inspect the work. [image] He approves. [image]

Pre-Release | Of Course I Still Love You

Supplies : Black 1/8" Acrylic Proofgrade (beta), Cork backing & acrylic paint. Rockets. Everyone loves rockets. What makes a rocket cooler? Landing. Vertically. From space (Okay upper atmosphere… But still.) What’s even cooler? Landing a rocket from space on a ship. Not any ship- A DRONE ship. [image] So this is where this adventure starts. This story will have happiness, nerd rage and glee. As usual I start out in Fusion 360. [image] [image] I created a sketch and use the project tool…

Pre-Release | SKOGSTA

Supplies : Ikea Cutting board Op time : 19mins 33sec Ikea is an incredible place. Glowforge + Ikea Cutting board = Custom one of a kind art. The cutting board was pretty thick which meant the tray had to come out. I needed to raise the cutting board a bit so the depth checker routine could detect the board. I used a spool of electrical tape to act as a spacer/stand for the board. [image] I pre-masked the board and drew some lines so I knew where the center, hole and the corners where. The…

Pre-Release | Badge of Honor

Supplies: Proofgrade 1/4" Acrylic & 1/8" Walnut Hardwood - Op Time: 1/4" Acrylic @ 450 LPI 10mins - 1355 LPI 37mins - Walnut Hardwood @ 450 LPI 10 mins. I want to start this post with- I hate Blender. It’s seems overly complex. I am sure it’s good at what it does. But damn. Anyway. Fusion 360. [image] Blender. [image] [image] AI. [image] Glowforge. [image] [image] [image] [image] [image] [image] [image] Dang. The inverted one is my fav.